What It Means
Hot surface igniter failure or incorrect current draw.
American Standard Furnace
American Standard Furnace Error Code 9 Flashes
Troubleshooting guide for the American Standard Furnace system fault 9 Flashes.
ACLogics Fix American Standard code 9 Flashes See how ACLogics handles it → Fix 9 Flashes step-by-step
Possible Causes
- Cracked, damaged, or burned-out igniter.
- Loose or damaged igniter wiring harness.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Igniter problem. The hot surface ignitor failed to light the burners or is not drawing the correct current.
All Recorded Causes
Inspect the igniter for cracks or damage (it’s brittle). If cracked or not glowing, replace the igniter. Check the wiring harness to the igniter for loose connections. After replacement, reset the furnace and verify ignition.
Verify Before Replacing Parts
- Confirm the exact American Standard model family and furnaces context before acting on a generic code description.
- Walk the entire heating sequence in order instead of jumping straight to the reported code, watching for inspect the igniter for cracks or damage (it’s brittle).
- Verify each safety device and prove where the sequence stops under live operation, including whether if cracked or not glowing, replace the igniter.
- After the correction, run the system long enough to confirm the furnaces fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through American Standard Furnace diagnostics step-by-step — so you confirm the cause before swapping parts.
