What It Means
Compressor B1 current sensor misread or contactor fault.
Carrier Packaged Unit
Carrier Packaged Unit Error Code 55
Troubleshooting guide for the Carrier Packaged Unit system fault 55.
Possible Causes
- Loose or damaged compressor B1 power wiring.
- Faulty or mispositioned current sensor.
- Open compressor B1 motor winding.
- Welded contactor contacts feeding off-state current.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Compressor B1 Alert. Current sensor does not detect compressor B1 current during operation, or detects current when compressor B1 should be off.
All Recorded Causes
Check compressor B1 wiring and contactor. Verify current sensor wiring and positioning. Test for compressor B1 open winding or open circuit. Inspect compressor contactor for welded contacts if current detected after turnoff.
Verify Before Replacing Parts
- Confirm the exact Carrier model family and outdoor packaged units context before acting on a generic code description.
- Verify the sensor or thermistor reading against the expected range for the current operating condition, keeping in mind that check compressor B1 wiring and contactor.
- Check the sensor harness and board connection before condemning the sensor itself; on Carrier units this is also where you'd confirm verify current sensor wiring and positioning.
- After the correction, run the system long enough to confirm the outdoor packaged units fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Carrier Packaged Unit diagnostics step-by-step — so you confirm the cause before swapping parts.
