What It Means
Missing or unreadable shared model data.
Rheem Furnace
Rheem Furnace Error Code d1
Troubleshooting guide for the Rheem Furnace system fault d1.
Possible Causes
- Missing or disconnected memory card.
- Unreadable or wrong shared data card.
- Communicating system data unavailable.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
No model data / no shared data available.
All Recorded Causes
Missing or disconnected memory/model data card, wrong or unreadable shared data, replacement control installed without the original memory card, or communicating system data not available.
Verify Before Replacing Parts
- Confirm the exact Rheem model family and furnaces context before acting on a generic code description.
- Start with the exact model documentation and verify the full operating sequence before replacing parts, particularly around missing or disconnected memory/model data card, wrong or unreadable shared data, replaceme….
- Use the listed causes as branches to confirm or eliminate with measurements, not assumptions — the next candidate on the list is a reasonable second branch.
- After the correction, run the system long enough to confirm the furnaces fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Rheem Furnace diagnostics step-by-step — so you confirm the cause before swapping parts.
