What It Means
Outdoor condenser pipe temperature sensor error.
L
Luxaire All Systems
Luxaire Error Code F2
Troubleshooting guide for the Luxaire system fault F2.
Possible Causes
- Open or shorted condenser pipe thermistor.
- Loose or damaged sensor wire connector.
- Defective condenser coil temperature sensor.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Outdoor condenser pipe sensor error.
All Recorded Causes
Verify Before Replacing Parts
- Confirm the exact Luxaire model family and default context before acting on a generic code description.
- Verify the sensor or thermistor reading against the expected range for the current operating condition, keeping in mind that the most likely cause listed above.
- Check the sensor harness and board connection before condemning the sensor itself; on Luxaire units this is also where you'd confirm the next candidate on the list.
- After the correction, run the system long enough to confirm the default fault does not return under normal load.
Not sure which system this Luxaire code is on?
ACLogics has guided diagnostics for 60 Luxaire fault codes and asks the right questions to narrow it down.
