What It Means
Control board detected missing or invalid model-plug information.
Bryant Air Conditioner
Bryant Air Conditioner Error Code 25
Troubleshooting guide for the Bryant Air Conditioner system fault 25.
Possible Causes
- Missing or incorrectly installed model plug.
- Incorrect model plug part number.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Invalid Model. Invalid model or model-plug information detected.
All Recorded Causes
Install the correct model plug for this specific unit model. Verify model plug part number. Unit will not operate until a valid model plug is detected by the control board.
Verify Before Replacing Parts
- Confirm the exact Bryant model family and air conditioners context before acting on a generic code description.
- Start with line voltage, low voltage, and board output checks in sequence so the fault is isolated cleanly — the data plate flags install the correct model plug for this specific unit model.
- Inspect connectors, relay outputs, and any recently replaced electrical parts for mismatch or loose fit, and verify verify model plug part number.
- After the correction, run the system long enough to confirm the air conditioners fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Bryant Air Conditioner diagnostics step-by-step — so you confirm the cause before swapping parts.
