What It Means
Compressor motor failed to start upon demand.
Bryant Air Conditioner
Bryant Air Conditioner Error Code 62
Troubleshooting guide for the Bryant Air Conditioner system fault 62.
Possible Causes
- Insufficient voltage or failed contactor.
- Defective compressor windings or mechanical lockup.
- Inverter drive output fault.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Compressor No Start. Compressor failed to start.
All Recorded Causes
Check supply voltage at compressor terminals. Inspect compressor wiring and contactor operation. Test compressor winding resistance. Check for high-pressure lockout conditions. Inspect inverter drive for faults. Board retries after 15 minutes.
Verify Before Replacing Parts
- Confirm the exact Bryant model family and air conditioners context before acting on a generic code description.
- Confirm board LEDs, wiring polarity, and model compatibility before replacing control boards — this Bryant fault points at check supply voltage at compressor terminals.
- Check for intermittent communication faults caused by connectors, moisture, or damaged harnesses, and rule out inspect compressor wiring and contactor operation.
- After the correction, run the system long enough to confirm the air conditioners fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Bryant Air Conditioner diagnostics step-by-step — so you confirm the cause before swapping parts.
