What It Means
Defective outdoor unit PCB.
Daikin Split & Multi-Split
Daikin Split & Multi-Split Error Code E1
Troubleshooting guide for the Daikin Split & Multi-Split system fault E1.
Possible Causes
- Defective outdoor unit PCB.
- Defective connection of inside/ outside relay wires.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Defective outdoor unit PCB
All Recorded Causes
Defective outdoor unit PCB Defective connection of inside/ outside relay wires
Verify Before Replacing Parts
- Confirm the exact Daikin model family and split/ multi split context before acting on a generic code description.
- Start with line voltage, low voltage, and board output checks in sequence so the fault is isolated cleanly — the data plate flags defective outdoor unit PCB.
- Inspect connectors, relay outputs, and any recently replaced electrical parts for mismatch or loose fit, and verify defective connection of inside/ outside relay wires.
- After the correction, run the system long enough to confirm the split/ multi split fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Daikin Split & Multi-Split diagnostics step-by-step — so you confirm the cause before swapping parts.
