What It Means
Malfunction of transmission between indoor and outdoor unit.
Daikin Split & Multi-Split
Daikin Split & Multi-Split Error Code U4
Troubleshooting guide for the Daikin Split & Multi-Split system fault U4.
Possible Causes
- Short circuit in indoor-outdoor or outdoor-outdoor transmission wiring (F1 / F2), or wrong wiring.
- Outdoor unit power supply is OFF.
- System address does not match.
- Defective indoor unit PCB.
- Defective outdoor unit PCB.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Malfunction of transmission between indoor and outdoor unit
All Recorded Causes
Short circuit in indoor-outdoor or outdoor-outdoor transmission wiring (F1 / F2), or wrong wiring Outdoor unit power supply is OFF System address does not match Defective indoor unit PCB Defective outdoor unit PCB
Verify Before Replacing Parts
- Confirm the exact Daikin model family and split/ multi split context before acting on a generic code description.
- Start with line voltage, low voltage, and board output checks in sequence so the fault is isolated cleanly — the data plate flags short circuit in indoor-outdoor or outdoor-outdoor transmission wiring (F1 / F2), or wrong….
- Inspect connectors, relay outputs, and any recently replaced electrical parts for mismatch or loose fit, and verify outdoor unit power supply is OFF.
- After the correction, run the system long enough to confirm the split/ multi split fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Daikin Split & Multi-Split diagnostics step-by-step — so you confirm the cause before swapping parts.
