What It Means
Inverter compressor motor or overheat.
Daikin Split & Multi-Split
Daikin Split & Multi-Split Error Code E5
Troubleshooting guide for the Daikin Split & Multi-Split system fault E5.
Possible Causes
- Inverter compressor lock.
- High differential pressure.
- Defective inverter PCB.
- UVW connection error.
- Defective connector contact.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Inverter compressor motor or overheat
All Recorded Causes
Inverter compressor lock High differential pressure Defective inverter PCB UVW connection error Defective connector contact
Verify Before Replacing Parts
- Confirm the exact Daikin model family and split/ multi split context before acting on a generic code description.
- Confirm board LEDs, wiring polarity, and model compatibility before replacing control boards — this Daikin fault points at inverter compressor lock.
- Check for intermittent communication faults caused by connectors, moisture, or damaged harnesses, and rule out high differential pressure.
- After the correction, run the system long enough to confirm the split/ multi split fault does not return under normal load.
Still unsure about this fault?
ACLogics walks you through Daikin Split & Multi-Split diagnostics step-by-step — so you confirm the cause before swapping parts.
