What It Means
Outdoor board LED flash diagnostic for pipe thermistor short or open.
Mitsubishi Electric All Systems
Mitsubishi Electric Error Code LED LD3
(Flash)
Troubleshooting guide for the Mitsubishi Electric system fault LED LD3 (Flash).
ACLogics Fix Mitsubishi Electric code LED LD3 (Flash) See how ACLogics handles it → Fix LED LD3 (Flash) step-by-step
Possible Causes
- Outdoor pipe thermistor open or short circuit.
- Pipe thermistor wiring or connector fault.
Not sure which one it is — or if it's none of these? Try ACLogics today.
Disclaimer: This information is for general reference. Error codes can vary by model and production year. Always refer to your machine's specific manual and the information printed on the unit itself.
New to this code? Click to see why this happens
Full Diagnosis
Pipe sensor short/open
All Recorded Causes
Verify Before Replacing Parts
- Confirm the exact Mitsubishi Electric model family and default context before acting on a generic code description.
- Verify the sensor or thermistor reading against the expected range for the current operating condition, keeping in mind that the most likely cause listed above.
- Check the sensor harness and board connection before condemning the sensor itself; on Mitsubishi Electric units this is also where you'd confirm the next candidate on the list.
- After the correction, run the system long enough to confirm the default fault does not return under normal load.
Not sure which system this Mitsubishi Electric code is on?
ACLogics has guided diagnostics for 73 Mitsubishi Electric fault codes and asks the right questions to narrow it down.
